PIXEL Subscribe FR EN

Miner running hot: cleaning, thermal paste and cooling

A miner spends its life running hot, that is normal. But a chip that is too hot loses hashrate and wears faster. Here is how to spot the problem, fix it, and even gain hashrate along the way.

Published 24 September 2026 · by Pixel · 2 min read

Video The topic on video Play the video: I boosted my Bitcoin miner by 80% with a €35 fan 6:22
I boosted my Bitcoin miner by 80% with a €35 fan Video in French, with subtitles · open on YouTube The video loads from YouTube when you press play.

1. Spotting overheating

In AxeOS The open-source Bitaxe software, set from a browser: pool, frequency, voltage, fan. Update it, the dashboard shows the chip temperature, the voltage regulator temperature and the fan speed. Warning signs:

  • the chip temperature creeps up over the weeks, with the same settings;
  • the fan runs flat out all the time;
  • the hashrate Computing power: the number of attempts per second of a machine or of the whole network. The higher it is, the more tickets you play in each draw. drops or swings, or the machine restarts by itself.

As a rule of thumb, many miners keep the chip under about 65 °C. Above that, the software may lower the frequency to protect the machine.


2. Causes, most common first

  1. Dust in the heatsink and fan.
  2. A room that is too warm or a cramped spot (closed shelf, behind furniture).
  3. A worn fan, or one set too low.
  4. Dried thermal paste between chip and heatsink, after months of heat.
  5. An overclock Pushing the chip's frequency and voltage for more hashrate. It draws and heats noticeably more: on the Thor X1, +50% hashrate for 2.1 times the power. The review too aggressive for the cooling in place.

3. Cleaning and replacing thermal paste

  1. Unplug the machine and let it cool. Never touch a powered miner.
  2. Blow the dust out of the heatsink and fan (air can or blower), holding the blades so they do not overspin.
  3. If temperatures stay high, remove the heatsink and wipe off the old paste with a cloth and isopropyl alcohol.
  4. Apply a thin layer of non-conductive thermal paste: too much paste insulates instead of cooling.
  5. Reassemble, plug back in, and compare temperatures with the same settings.

The whole job on a NerdOctaxe: my cleaning and thermal paste video (in French).


4. Better cooling, more hashrate

Better cooling does more than protect: it leaves headroom to raise the frequency. In this video (in French), a €35 fan let me raise my miner’s hashrate by 80%.

  • Set the fan to automatic in AxeOS: it speeds up as the chip heats.
  • Swap the fan if yours is noisy or struggling: check the size and connector first.
  • Raise the frequency in small steps, watching the temperature each time. If it gets unstable or too hot, go back one step.

How far liquid cooling can go: my watercooling test (in French).

A question about this guide? Ask it on the Discord, several of us answer there.

Share X WhatsApp Telegram


Other guides

See all 41 guides

@pixel_pow All of this is on video too. Join the channel's 3.4K subscribers.
Subscribe

Back to the ticket

Back of the ticket: legal notice, privacy, terms